GROUND MOUNT INSTALLATION / DYNABOLT & HEX SET

Base Plate Installation (onto concrete slab)

If using Outback Clotheslines Base Plates, follow these steps:

1. Place one of the base plates at the starting point and drill only 1 hole and hammer a dynabolt in to that hole.
   
2. Adjust the base plate to the angle you like and when you are satisfied then proceed to drill the other 2 holes on the base plate.

3. Slide in the post for that base plate and then add the two spreader bars and connect it to the other post.

4. Now you have the clothesline assembled and with one side already bolted down.

5. Proceed to bolt down the other leg.

6. Tighten the bolts with your spanner or socket until the bolts no longer turn, that means it is fully gripped.

7. Get your spirit level and leave it in the middle of the top spreader bar and see if it is level.

8. If it is level then drill the hex screws in to the base plate holes and that will prevent the legs from moving.

9. If it is not level then get a hex bit and drill one of the holes. Once you have achieved an equal level then you have our permission to drill the other 5 hex screws.

6. Now just feed the line , tighten and tie it.

Congratulations on the installation, we never doubted you! You can use it now.